Panel Coker (Panel coking apparatus): Coking Tendency of oils

The panel coking apparatus to determine the tendencies of finished oils from coke when in contact with surfaces at elevated temperatures. It is designed to perform Fed. Test Standard 791 method 3462.

The unit is supplied with PID temperature indicating controllers for regulating the temperature of the test panel oil in the sump and air. It is equipped with a variable drive motor, digital speed display and air flow regulator system.

The optional Cyclic timing system conducts  alternate splash/bake cycles to allow oil bake for a period of time on the hot panel without the addition of fresh lubricants. The optional sulphur dioxide gas system allows for the introduction of a corrosive acidic atmosphere thus increasing the severity of the evaluation.

PANEL COKING APPARATUS COMPRISES OF

Speed Ten turn variable speed control pot. Speed range from 100 to 2500 rpm.
Temperature
Three Heating System
Panel 540 Degree Celsius ( 1000 Degree F ) Maximum
Sump 300 Degree Celsius ( 572 Degree F) maximum
Air 40 Degree Celsius ( 104 Degree F) Maximum
Atmospheres Variable airflow or other inert gases from 0.2 to 1.0 liters per minute is standard. Optional Acidic Atmosphere Chamber and Delivery System is available to supply and monitor corrosive sulphur dioxide ( SO2) atmospheres in various concentrations.
Timing System Timer with automatic shut down. Optional cyclic timing system for alternating/bake cycles.
Acidic Atmosphere Chamber and Delivery System Optional system to introduce and monitor corrosive Sulphur Dioxide ( SO2 ) atmosphere.
Motor 1/18 HP
Power 220/110 V
Single Phase
50/60 Cycles
20 amps
Includes On/Off Timer
Variable Speed Motor
Air Flow Regulator
PID Electronic Temperature Controllers
Lubricant Delivery System

Accessories

  • Cyclic Timing System: Allows for alternating splash/bake cycle.
  • Sulphur Dioxide Gas Supply System
  • Sealed chamber and SO2 delivery system to introduce and monitor corrosive acidic atmospheres. Includes acid monitoring meter..
  • Specimen Test Panels: 3-7/16 x 1 1/4 x 1 1/4 inch test panel available in various materials.
  • B1 Soft Aluminum, 3003-F
  • B2 Aluminum 2024-T351 (QQ-A-355)
  • C Cold Rolled Steel
  • D Type 321 Stainless Steel (Other materials available upon request)